|
Public Forum | Proceed to Auspet's New Discussion Forum | Pet Directory | Classifieds | Home | LinkXchange |
Click here to make Auspet.com your default home page |
Auspet - Message Boards
Fish and Aquarium Needed -- Tips on building Glass aquariums
|
UBBFriend: Email This Page to Someone! | next newest topic | next oldest topic |
Author | Topic: Needed -- Tips on building Glass aquariums |
Fish Addict Member Posts: 122 |
posted 03-04-2004 08:51 PM
Hey all I am looking for tips on building aquariums things you have learn tools you recommend etc… Peace Fish Addict ------------------ IP: Logged |
t_chelle16 Member Posts: 501 |
posted 03-04-2004 09:01 PM
When I did my 10 gallon, I had the glass professionally cut (I could never get it to break right when I tried). Then I basically just took some fine sand paper and scuffed up the areas where the joints would be (so the silicone would stick). Then I layed out the bottom, put a bead of silicone down and attached the back pane using a couple strips of electrical tape to hold it. Then I did the sides, then the front in the same manner. I added another bead of silicone on all the inside seams and smoothed it out with my finger. I let it dry for 24 hours and filled it with water to see if it would leak. Another set of hands would have been helpful to hold the panes in place while I applied the electrical tape, but other than that it wasn't too difficult. -Chelle IP: Logged |
a1964model New Member Posts: 3 |
posted 03-05-2004 02:25 PM
Here's a good site that will even give you the dimensions to have the glass cut. There is also some interesting articles on building plywood tanks with glass panels (for built-in aquariums). http://www.garf.org/ Look under the "How-to" pages on the left side of the page. [This message has been edited by a1964model (edited 03-05-2004).] IP: Logged |
All times are ET (US) | next newest topic | next oldest topic |
Home | Contact us | Advertise here | Jobs at Auspet | |
© 1999-2017 AusPet.com |